Clips are usually spaced about six-wire rope diameters apart to give adequate holding power. They should be tightened before the rope is placed under tension. After the load is placed on the rope, tighten the clips again to take care of any lessening in rope diameter caused by the tension of the load. A wire rope thimble should be used in the eye of the loop to prevent kinking.
Also called a clamp, cable clamp, wire rope clamp, U-Clip, U-Clamp, they are used to fix the loose end of the loop back to the wire rope.
Sizes:
1/4”, 3/8”, 1/2”, 5/8”, 3/4”, 1”, 1-1/2”